Memory
• SDRAM: 2GB
• Flash: 8GB

Serial Interface
• 2x Programmable Bi-directional RS-232/422/485 ports (2x 5-pole terminal block connectors, configurable via pin assignments)
– Baud Rate: 300 to 115200 (default: 9600)
– Data Bit: 8 (default) or 7
– Stop Bit: 1 (default) or 2
– Parity: None (default), Even or Odd
– Flow Control: None (default) or RTS/CTS
• 6x Bi-directional RS-232 ports (6x 3-pole terminal block connectors)
– Baud Rate: 300 to 115200 (default: 9600)
– Data Bit: 8 (default) or 7
– Stop Bit: 1 (default) or 2
– Parity: None (default), Even or Odd

IR/Serial Interface
• 8x Programmable IR / Uni-directional RS-232 ports (4x 4-pole terminal block connectors);
• IR: TTL level (0 to 5 V)
– Carrier Frequency: 10KHz~455KHz;
• Serial: Uni-directional RS-232 (0 to 5 V)
– Baud Rate: 300 to 115200 (default: 9600)
– Data Bit: 8 (default) or 7
– Stop Bit: 1 (default) or 2
– Parity: None (default), Even or Odd

Relay Interface
8x Relay Channel (4x 4-pole terminal block connectors)
• Normally open, isolated Relays
• Contact Rating: Max 24 VDC, 2A

I/O Interface
• 8x Programmable Digital Input / Output Channel (2x 5-pole terminal block connectors)
• Digital Output: 300 mA sink from 24 VDC
• Digital Input: VDC Mode
– Input Voltage Range: 0 to 24 VDC
– Programmable Range: 1 to 24 VDC
• Digital Input: Dry Contact Mode
– Pull-up 2k ohms to + 12 VDC

Ethernet Interface
• 2x RJ-45 Female, 10/100/1000Base-T
• Supported Protocol: ARP, ICMP, TCP/IP, DHCP, HTTPS, SSH

Control LAN
• Support DHCP Server
• DHCP mode - The following default IP settings will be used if no IP is assigned within 30 seconds
– IP: 192.168.0.60
– Subnet Mask: 255.255.255.0

LAN
• DHCP mode - The following default IP settings will be used if no IP is assigned within 30 seconds:
– IP: 192.168.1.60
– Subnet Mask: 255.255.255.0

VDC Interfaces
• 4x 12 VDC Output ports (2x 4-pole terminal block connectors);
• Power Supply: 12 VDC, 2A Max (shared by 4 ports)

Panel
• Size: 1.6"
• Resolution: 128x64

Operations
1x Power On/Off switch
1x IR receiver LED for IR learning
3x Push-buttons (Up, Down, Enter) for selection
1x Semi-recessed push-button for reset
1x USB Type-A

Licenses
• Basic (free): 2 free licenses
• Max. No. Allowed: 32 licenses
• ATEN Control Box comes with two free licenses which are stored in the device itself; each time a mobile device connects to an ATEN Control Box for remote control, one license on the Control Box will be occupied

Power
• Consumption: AC110V:5.7W:139BTU AC220V:6.8W:144BTU
• Internal Power: 100-240 VAC, 50-60 Hz

Environmental
• Operating Temperature: 0 – 50°C
• Storage Temperature: –20 – 60°C
• Humidity: 0 - 80% RH, Non-Condensing

Physical
• Housing: Metal
• Weight: 2.62 kg (5.77 lb)
• Dimensions (L x W x H): 43.24x 16.32x 4.4 cm (17.02x 6.43 x 1.73 in.)